EDGE TOUCH OFF GAGE 0.001 GRADUATION

The Touch Off Gage allows you to standardize the way tool offsets are measured in your shop. To use this gage just lower the tool down onto the contact face until the indicator reads zero. At that point the tool tip is exactly 4 inches from the surface the Touch Off Gage is sitting on.

FEATURES:

• Accurately establishes tool length offsets for CNC milling machines.
• The contact face is lightly spring loaded to protect against overrun.
• Contact face diameter is .250".
• The rectangular base and recessed indictor face allow it to fit between vise jaws on a pair of parallel bars.
• Offset height 4" (101.6mm).
• Large 2.2" easy to read indicator face.
• Easy calibration check using 1-2-3 blocks.
• Gage graduations: .001".
• Gage repeatability: .0002".
• Body and contact face are made from red anodized 6061-T6 aluminum.
• Padded case and manual included.

EDGE TECHNOLOGY TOUCH OFF GAGE 0.001" GRADUATION WITH MANUAL AND PADDED CASE